Cisco Cisco FirePOWER Appliance 7030
9-10
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
•
•
To add a virtual router:
Access:
Admin/Network Admin
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device where you want to add the virtual router, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Tip
If your devices are in a clustered stack deployment, select the stack you want to modify from the
Selected
Device
drop-down list.
Step 4
Click
Add Virtual Router
.
The Add Virtual Router pop-up window appears.
Step 5
In the
Name
field, type a name for the virtual router. You can use alphanumeric characters and spaces.
Step 6
To enable IPv6 static routing, OSPFv3, and RIPng on your virtual router, select the
IPv6 Support
check
box. To disable these features, deselect the check box.
Step 7
Optionally, clear
Strict TCP Enforcement
if you do not want to enable strict TCP enforcement.
This option is enabled by default.
Step 8
Under
Interfaces
, the
Available
list contains all enabled Layer 3 interfaces, routed and hybrid, on the
device that you can assign to the virtual router. Select one or more interfaces to assign to the virtual
router and click
router and click
Add
.
Tip
To remove a routed or hybrid interface from the virtual router, click the delete icon (
). Disabling a
configured interface from the Interfaces tab also removes it.
Step 9
Click
Save
.
The virtual router is added. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
.
Setting Up DHCP Relay
License:
Control
Supported Devices:
Series 3