Cisco Cisco FirePOWER Appliance 7010
D-29
FireSIGHT System User Guide
Appendix D Command Line Reference
Configuration Commands
manager
The
configure manager
commands configure the device’s connection to its managing Defense Center.
Access
Configuration
add
Configures the device to accept a connection from a managing Defense Center. This command works
only if the device is not actively managed.
only if the device is not actively managed.
A unique alphanumeric registration key is always required to register a device to a Defense Center. In
most cases, you must provide the hostname or the IP address along with the registration key. However,
if the device and the Defense Center are separated by a NAT device, you must enter a unique NAT ID,
along with the registration key, and specify
most cases, you must provide the hostname or the IP address along with the registration key. However,
if the device and the Defense Center are separated by a NAT device, you must enter a unique NAT ID,
along with the registration key, and specify
DONTRESOLVE
instead of the hostname.
Syntax
configure manager add {hostname | IPv4_address | IPv6_address | DONTRESOLVE} regkey
[nat_id]
where
{hostname | IPv4_address | IPv6_address | DONTRESOLVE}
specifies the DNS host name or
IP address (IPv4 or IPv6) of the Defense Center that manages this device. If the Defense Center is not
directly addressable, use
directly addressable, use
DONTRESOLVE.
If you use
DONTRESOLVE,nat_id
is required.
regkey
is the
unique alphanumeric registration key required to register a device to the Defense Center.
nat_id
is an
optional alphanumeric string used during the registration process between the Defense Center and the
device. It is required if the hostname is set to
device. It is required if the hostname is set to
DONTRESOLVE.
Example
> configure manager add DONTRESOLVE abc123 efg456
delete
Removes the Defense Center’s connection information from the device. This command only works if the
device is not actively managed.
device is not actively managed.
Syntax
configure manager delete
Example
> configure manager delete
mpls-depth
Configures the number of MPLS layers on the management interface. This command is not available on
virtual devices and ASA FirePOWER devices.
virtual devices and ASA FirePOWER devices.
Access
Configuration