Cisco Cisco FirePOWER Appliance 7010
6-21
FireSIGHT System User Guide
Chapter 6 Managing Devices
Configuring Remote Management
Step 5
For NAT environments, in the
Unique NAT ID
field, type a unique alphanumeric NAT ID that you want to
use to set up communications between appliances.
Step 6
Click
Save
.
After the appliances confirm that they can communicate with each other, the Pending Registration status
appears.
appears.
Step 7
Use the managing appliance’s web interface to add this appliance to your deployment.
For more information, see
Note
When enabling remote management of a device, in some high availability deployments that use
NAT, you may also need to add the secondary Defense Center as a manager. For more
information, contact Support.
NAT, you may also need to add the secondary Defense Center as a manager. For more
information, contact Support.
Editing Remote Management
License:
Any
Use the following procedure to edit the hostname or IP address of the managing appliance. You can also
change the display name of the managing appliance, which is a name only used within the context of the
FireSIGHT System. Although you can use the hostname as the display name of the appliance, entering
a different display name does not change the hostname.
change the display name of the managing appliance, which is a name only used within the context of the
FireSIGHT System. Although you can use the hostname as the display name of the appliance, entering
a different display name does not change the hostname.
Note that you cannot add devices running software more than one major version lower than the Defense
Center. For example, if your Defense Center is running Version 5.3.0, you can add devices running 5.2.x
or higher but not devices running 5.1.x.
Center. For example, if your Defense Center is running Version 5.3.0, you can add devices running 5.2.x
or higher but not devices running 5.1.x.
Tip
You can click the slider to block the communication channel between the managed device and the
Defense Center. Click the slider to re-enable the communication channel.
Defense Center. Click the slider to re-enable the communication channel.
To edit remote management:
Access:
Admin
Step 1
Select
System > Local > Registration
.
The Remote Management page appears.
Step 2
Click the edit icon (
) next to the manager for which you want to edit remote management settings.
The Edit Remote Management page appears.
Step 3
In the
Name
field, change the display name of the managing appliance.
Step 4
In the
Host
field, change the IP address or the hostname of the managing appliance.
The hostname is the fully qualified domain name or the name that resolves through the local DNS to a
valid IP address.
valid IP address.
Step 5
Click
Save
.
Your changes are saved.