Cisco Cisco FirePOWER Appliance 8390
51-12
FireSIGHT System User Guide
Chapter 51 Configuring Appliance Settings
Setting the Time Manually
Caution
Do not shut off appliances using the power button; it may cause a loss of data. Shut down appliances
completely via the Appliance Process page.
completely via the Appliance Process page.
To shut down or restart your appliance:
Access:
Admin
Step 1
Select
System > Local > Configuration
.
The Information page appears.
Step 2
Click
Process
.
The Appliance Process page appears.
Step 3
Specify the command you want to perform:
On Defense Centers:
•
To shut down the appliance, click
Run Command
next to
Shutdown
Defense Center.
•
To reboot the appliance, click
Run Command
next to
Reboot
Defense Center. Note that this logs you
out of the Defense Center.
•
To restart the appliance, click
Run Command
next to
Restart
Defense Center
Console
. Note that
restarting the Defense Center may cause deleted hosts to reappear in the network map.
On managed devices:
•
To shut down the appliance, click
Run Command
next to
Shutdown Appliance
.
•
To reboot the appliance, click
Run Command
next to
Reboot Appliance
. Note that this logs you out of
the device.
•
To restart the appliance, click
Run Command
next to
Restart Appliance Console
.
•
To restart the Snort process, click
Run Command
next to
Restart Snort
.
Setting the Time Manually
License:
Any
If the Time Synchronization setting in the currently applied system policy is set to
Manually in Local
Configuration
, then you can manually set the time for the appliance using the Time page in the local
configuration.
You must use native applications, such as command line interfaces or the operating system interface, to
manage time settings for Sourcefire Software for X-Series. For more information, see the Sourcefire
Software for X-Series Installation Guide.
manage time settings for Sourcefire Software for X-Series. For more information, see the Sourcefire
Software for X-Series Installation Guide.
If the appliance is synchronizing its time based on NTP, you cannot change the time manually. Instead,
the NTP Status section on the Time page provides the following information:
the NTP Status section on the Time page provides the following information: