Cisco Cisco FirePOWER Appliance 8390
9-14
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
Step 2
Next to the device where you want to add the static route, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Step 4
Next to the virtual router where you want to add the static route, click the edit icon (
).
The Edit Virtual Router pop-up window appears.
Step 5
Click
Static
to display the static route options.
Step 6
Click
Add Static Route
.
The Add Static Route pop-up window appears.
Step 7
In the
Route Name
field, type a name for the static route. You can use alphanumeric characters and spaces.
Step 8
For
Enabled
, select the check box to specify that the route is currently enabled.
Step 9
In the
Preference
field, type a numerical value between 1 and 65535 to determine the route selection.
If you have multiple routes to the same destination, the system selects the route with the higher
preference.
preference.
Step 10
From the
Type
drop-down list, select the type of static route you are configuring.
Step 11
In the
Destination
field, type the IP address for the destination network where traffic should be routed.
Step 12
In the
Gateway
field, you have two options:
•
If you selected
IP
as the selected static route type, type an IP address.
•
If you selected
Interface
as the selected static route type, select an enabled interface from the
drop-down list.
Tip
Interfaces you have disabled from the Interfaces tab are not available; disabling an interface you have
added removes it from the configuration.
added removes it from the configuration.
Step 13
Click
OK
.
The static route is added.
Step 14
Click
Save
.
Your changes are saved. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
.
Setting Up Dynamic Routing
License:
Control
Supported Devices:
Series 3
Dynamic, or adaptive, routing uses a routing protocol to alter the path that a route takes in response to a
change in network conditions. The adaptation is intended to allow as many routes as possible to remain
valid, that is, have destinations that can be reached in response to the change. This allows the network
to “route around” damage, such as loss of a node or a connection between nodes, so long as other path
choices are available. You can configure a router with no dynamic routing, or you can configure the
Routing Information Protocol (RIP) or the Open Shortest Path First (OSPF) routing protocol.
change in network conditions. The adaptation is intended to allow as many routes as possible to remain
valid, that is, have destinations that can be reached in response to the change. This allows the network
to “route around” damage, such as loss of a node or a connection between nodes, so long as other path
choices are available. You can configure a router with no dynamic routing, or you can configure the
Routing Information Protocol (RIP) or the Open Shortest Path First (OSPF) routing protocol.