Cisco Cisco FirePOWER Appliance 8390
9-24
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
The Device Management page appears.
Step 2
Next to the device where you want to add the OSPF interface, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Step 4
Next to the virtual router where you want to add the OSPF interface, click the edit icon (
).
The Edit Virtual Router pop-up window appears.
Step 5
Click
Dynamic Routing
to display the dynamic routing options.
Step 6
Click
OSPF
to display the OSPF options.
Step 7
Under
Areas
, click the add icon (
).
The Add OSPF Area pop-up window appears.
Step 8
Click
Interfaces
.
The Interfaces tab appears.
Step 9
Click the add icon (
).
The Add OSPF Area Interface pop-up window appears.
Step 10
Take any of the actions as described in
Step 11
Optionally under
Neighbors
, click the add icon (
).
Step 12
In the
IP address
field, type an IP address for the neighbor receiving hello messages on non-broadcast
networks from this interface.
Step 13
Select the
Eligible
check box to indicate that the neighbor is eligible to receive messages.
Step 14
Click
OK
.
The neighbor is added.
Tip
To edit a neighbor, click the edit icon (
). To delete a neighbor, click the delete icon (
).
Step 15
Click
OK
.
The OSPF area interface is added.
Step 16
Click
Save
.
The OSPF area is saved.
Step 17
Click
Save
.
Your changes are saved. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
.
Adding OSPF Area Vlinks
License:
Control
Supported Devices:
Series 3