Cisco Cisco FirePOWER Appliance 8130
6-34
FireSIGHT System User Guide
Chapter 6 Managing Devices
Clustering Devices
Note
Cisco recommends that you use the default values, unless your deployment presents a good reason to
change them. Decreasing the values allows increased clustered peer readiness, while increasing the
values allows better performance.
change them. Decreasing the values allows increased clustered peer readiness, while increasing the
values allows better performance.
To establish clustered state sharing:
Access:
Admin/Network Admin
Step 1
Configure HA link interfaces for each device in the cluster.
See
for more information.
Step 2
Select
Devices > Device Management
.
The Device Management page appears.
Step 3
Next to the device cluster you want to edit, click the edit icon (
).
The Cluster page appears.
Step 4
Next to the
State Sharing
section, click the edit icon (
).
The State Sharing pop-up window appears.
Step 5
Configure the state sharing, as described earlier in this section.
Step 6
Click
OK
.
Your changes are saved. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
for more information.
Troubleshooting Clustered State Sharing
License:
Control
Supported Devices:
Series 3
After you enable state sharing, you can view the following information about the configuration in the
State Sharing section of the Cluster page:
State Sharing section of the Cluster page:
•
The HA link interface that is being used and its current link state
•
Detailed synchronization statistics for troubleshooting issues
The state sharing statistics are primarily counters for different aspects of the clustered synchronization
traffic sent and received, along with some other error counters. In addition, you can view the latest
system logs for each device in the cluster.
traffic sent and received, along with some other error counters. In addition, you can view the latest
system logs for each device in the cluster.
See the following sections for more information about the statistics you can view for each device and
how you can use them to troubleshoot your clustered state sharing configuration.
how you can use them to troubleshoot your clustered state sharing configuration.
Messages Received (Unicast)
Messages received are the number of cluster synchronization messages received from the clustered
peer.
peer.
The value should be close to the number of messages sent by the peer. During active use, the values
may not match, but should be close. If traffic stops, the values should become stable and the
messages received will match the messages sent.
may not match, but should be close. If traffic stops, the values should become stable and the
messages received will match the messages sent.