Cisco Cisco FirePOWER Appliance 8130
9-16
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
The Add an Interface pop-up window appears.
Step 8
From the
Name
drop-down list, select the interface where you want to configure RIP.
Tip
Interfaces you have disabled from the Interfaces tab are not available; disabling an interface you have
added removes it from the configuration.
added removes it from the configuration.
Step 9
In the
Metric
field, type a metric for the interface. When routes from different RIP instances are available
and all of them have the same preference, the route with the lowest metric becomes the preferred route.
Step 10
From the
Mode
drop-down list, select one of the following options:
•
Multicast
— default mode where RIP multicasts the entire routing table to all adjacent routers at a
specified address.
•
Broadcast
— forces RIP to use broadcast (for example, RIPv1) even though multicast mode is
possible.
•
Quiet
— RIP will not transmit any periodic messages to this interface.
•
No Listen
— RIP will send to this interface but not listen to it.
Step 11
Click
Save
.
Your changes are saved. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
.
Configuring Authentication Settings for RIP Configuration
License:
Control
Supported Devices:
Series 3
RIP authentication uses one of the authentication profiles you configured on the virtual router. For more
information about configuring authentication profiles, see
information about configuring authentication profiles, see
.
To configure authentication settings for RIP configuration:
Access:
Admin/Network Admin
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device where you want to add the RIP authentication profile, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Step 4
Next to the virtual router where you want to add the RIP authentication profile, click the edit icon (
).
The Edit Virtual Router pop-up window appears.
Step 5
Click
Dynamic Routing
to display the dynamic routing options.
Step 6
Click
RIP
to display the RIP options.