Cisco Cisco Firepower Management Center 2000
6-30
FireSIGHT System User Guide
Chapter 6 Managing Devices
Clustering Devices
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device cluster where you want to edit the configuration, click the edit icon (
).
The Cluster page appears.
Step 3
Click
Stacks
.
The Stacks page appears.
From the
Selected Device
drop-down list, select the stack you want to modify.
Step 4
Next to the
General
section, click the edit icon (
).
The General pop-up window appears.
Step 5
In the
Name
field, type a new assigned name for the stack.
You may enter alphanumeric characters and special characters, with the exception of the following
characters, which are invalid: +, (, ), {, }, #, &, \, <, >, ?, ‘, and “.
characters, which are invalid: +, (, ), {, }, #, &, \, <, >, ?, ‘, and “.
Step 6
Click
Save
.
The new name is saved. Note that your changes do not take effect until you apply the stack configuration;
see
see
for more information.
Configuring Interfaces on a Clustered Device
License:
Control
Supported Devices:
Series 3
You can configure interfaces on individual devices in a cluster. However, you must also configure an
equivalent interface on the peer device in the cluster. For clustered stacks, you configure identical
interfaces on the primary devices of the stacks. When you configure virtual routers, you select the stack
where you want to configure the routers. See
equivalent interface on the peer device in the cluster. For clustered stacks, you configure identical
interfaces on the primary devices of the stacks. When you configure virtual routers, you select the stack
where you want to configure the routers. See
for more
information.
The Interfaces page of a clustered device includes the hardware and interfaces views that you find on an
individual device. See
individual device. See
for more information.
To configure interfaces on a clustered device:
Access:
Admin/Network Admin
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device cluster where you want to configure interfaces, click the edit icon (
).
The Cluster page appears.
Step 3
Click
Interfaces
.
The Interfaces page appears.
Step 4
From the
Selected Device
drop-down list, select the device you want to modify.