Cisco Cisco Packet Data Gateway (PDG) Guía Para Resolver Problemas
Getting Started
▀ Using the CLI for Initial Configuration
▄ Cisco ASR 5000 Series System Administration Guide
OL-22970-01
Using the CLI for Initial Configuration
The initial configuration consists of the following:
Configuring a context-level security administrator and hostname
Configuring the Ethernet interface(s) on the SPIO that is installed behind the primary SMC
Configuring the system for remote CLI access via Telnet, SSH, or FTP (secured or unsecured)
This section provides instructions for performing these tasks using the CLI.
Step 1
At the [local]host_name prompt enter:
The following prompt appears:
Step 2
Enter the context configuration mode by entering the following command:
The local context is the system‘s management context. Contexts allow you to logically group services or interfaces. A
single context can consist of multiple services and can be bound to multiple interfaces.
single context can consist of multiple services and can be bound to multiple interfaces.
The following prompt appears:
Step 3
Enter the following command to configure a context-level security administrator for the system:
Keyword/Variable
Description
<
>
Specifies the security administrator‘s name. The name can be between 1 and 32 alpha and/or numeric
characters and is case sensitive.
characters and is case sensitive.
<
>
Specifies the password for the security administrator. The password can be between 1 and 63 alpha and/or
numeric characters and is case sensitive.
numeric characters and is case sensitive.