Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch Notas de publicación
8
Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.5.x
Release Notes
Major Changes and Defects Corrected
Major Changes
Change in Flash file system
•
In version 1.3.5, the Flash file system was upgraded. This has implications
when upgrading from previous releases to version 1.3.5, and when
downgrading from 1.3.5 version to previous versions as described below.
when upgrading from previous releases to version 1.3.5, and when
downgrading from 1.3.5 version to previous versions as described below.
Upgrading from previous releases
During the first bootup of the new version, the flash file system is upgraded. Note
that:
that:
•
This process takes a few minutes. “…” progress in the Console will be
displayed during this process (not relevant to Sx200).
displayed during this process (not relevant to Sx200).
•
The syslog file is deleted during this process.
•
The original image file is deleted. The two images on the Flash after the
upgrade will have the same version (1.3.5).
upgrade will have the same version (1.3.5).
NOTE
Before upgrading to version 1.3.5, the boot loader also needs to be updated.
If version 1.3.5 is installed using the original boot loader, the file system will not be
upgraded, and in the future the user will not be allowed to upgrade to versions
higher than 1.3.5.
If version 1.3.5 is installed using the original boot loader, the file system will not be
upgraded, and in the future the user will not be allowed to upgrade to versions
higher than 1.3.5.
Downgrade from 1.3.5 to previous releases
•
The downgrade copy operation process takes a few minutes since the file
system needs to be converted prior to the copy operation itself. The user
will be notified (using “…..” progress on CLI or a message on the WEB GUI)
that the conversion process is ongoing. When the conversion process ends,
the image download begins automatically. The device will automatically
reboot after the copy is finished.
system needs to be converted prior to the copy operation itself. The user
will be notified (using “…..” progress on CLI or a message on the WEB GUI)
that the conversion process is ongoing. When the conversion process ends,
the image download begins automatically. The device will automatically
reboot after the copy is finished.
NOTE
Powering off the device during this process might damage the file system, in such
case, booting up might require connecting to the device using the console cable
(not relevant to Sx200) and loading the image file using XMODEM.
case, booting up might require connecting to the device using the console cable
(not relevant to Sx200) and loading the image file using XMODEM.
•
After the downgrade, only downloaded image file will remain on the Flash
(the 1.3.5 image is deleted during this process). Note that there’s no need to
downgrade the boot file, the boot file supports both file systems. The boot
file cannot be downgraded while version 1.3.5 is active.
(the 1.3.5 image is deleted during this process). Note that there’s no need to
downgrade the boot file, the boot file supports both file systems. The boot
file cannot be downgraded while version 1.3.5 is active.