Zebra 01219-901 Manual De Usuario
Programming
Software Command Syntax
Software Command Syntax
40
P1003643-001
TTP 1020™/TTP 1030™ Technical Manual
03/03/2009
This command defines the desired horizontal tab positions. Variables n1...nx represent each
tab position. Up to 16 tab positions are allowed. Minimum allowed value is “1”.
tab position. Up to 16 tab positions are allowed. Minimum allowed value is “1”.
Tab position 255 sets a tab stop on the last position of the line. Use this if you want underline
or reversed text to extend across the full paper width.
or reversed text to extend across the full paper width.
ESC F
n1 ... Nx NUL
Set horizontal tabs
1B
46
n1
...
Nx
00
hex
027
70
n1
...
Nx
000
decimal
Note •
The tab positions are always expressed in number of 2.5-mm steps.
n = 1
Means 2.5 mm from the left-hand edge of the print window.
Example •
Sets tab stops at 10, 20, 30, and 54 mm.
Send
→
ESC F 004 008 016 255 000
Note •
Do not use value n = 0. The values must be sorted from low to high numbers.