Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Brother
  4. CS7130
  5. Guía De Operación

Brother CS7130 Guía De Operación

Descargar
Página de 72
KNOWING YOUR SEWING MACHINE
23
1
2 
If the sewing machine has been turned on, 
turn it off.
CAUTION
•  Before replacing the presser foot, be sure to 
turn off the sewing machine, otherwise injuries 
may occur if the foot controller or the start/
stop button is accidentally pressed and the 
machine starts sewing.
3 
Raise the presser foot lever.
4 
Press the black button to release the presser 
foot.
1 
Black button
5 
Place a different presser foot below the 
presser foot holder so that the presser foot 
pin is aligned with the shank in the holder.
Position the presser foot so the letter indicating 
the presser foot type (J, A, etc.) is positioned to 
be read.
1 
Presser foot holder
2 
Shank
3 
Pin
Note
• The presser foot to be used with each stitch 
appears in the LCD. To select a stitch, refer 
to “Selecting a stitch” (page 24).
6 
Slowly lower the presser foot lever so that the 
pin snaps into the shank.
1 
Presser foot lever
2 
Shank
3 
Pin
 
X
The presser foot is attached.
7 
Raise the presser foot lever to check that the 
presser foot is securely attached.
Removing the presser foot 
holder
Remove the presser foot holder when cleaning the 
sewing machine or when installing a presser foot 
that does not use the presser foot holder, such as 
the quilting foot. Use the disc-shaped screwdriver to 
remove the presser foot holder.
1 
Remove the presser foot. (Refer to page 22.)
2 
Loosen the presser foot holder screw.
1 
Disc-shaped 
screwdriver
2 
Presser foot 
holder
3 
Presser foot 
holder screw
 
■
Attaching the presser foot holder
1 
Align the presser foot holder with the lower-
left side of the presser bar.
3
2
1
1 
Presser foot 
holder
2 
Presser bar
3 
Presser foot 
holder screw
2 
Holding the presser foot holder in place, 
tighten the screw.
Note
• If the presser foot holder is not correctly installed, 
the thread tension will be incorrect.
CAUTION
•  Be sure to securely tighten the presser foot 
holder screw, otherwise the presser foot 
holder may fall off and the needle may strike 
it, causing the needle to bend or break.