Brother Innov-is XV8500D Guía De Operación
SEWING
Se
w
in
g Ba
sics
83
2
g
Press the “Start/Stop” button to start
sewing.
sewing.
*
Guide the fabric lightly by hand.
h
Press the “Start/Stop” button again to stop
sewing.
sewing.
i
Press the “Thread Cutter” button to trim
the upper and lower threads.
the upper and lower threads.
→ The needle will return to the up position
automatically.
j
When the needle has stopped moving, raise
the presser foot and remove the fabric.
the presser foot and remove the fabric.
■ Using the Multi-Function Foot
Controller (Only for supplied
models)
models)
You can also use the foot controller to start and stop
sewing.
sewing.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the “Start/
Stop” button.
Stop” button.
CAUTION
• Do not press the “Thread Cutter” button after
the threads have been cut. Doing so could
tangle the thread or break the needle and
damage the machine.
tangle the thread or break the needle and
damage the machine.
• Do not press the “Thread Cutter” button when
there is no fabric set in the machine or during
machine operation. The thread may tangle,
possibly resulting in damage.
machine operation. The thread may tangle,
possibly resulting in damage.
Note
• When cutting thread thicker than #30, nylon
monofilament thread, or other decorative
threads, use the thread cutter on the side of
the machine.
threads, use the thread cutter on the side of
the machine.
Memo
• This machine is equipped with a bobbin
thread sensor that warns you when the
bobbin thread is almost empty. When the
bobbin thread is nearly empty, the machine
automatically stops. However, if the “Start/
Stop” button is pressed, a few stitches can
be sewn. When the warning displays, re-
thread the machine immediately.
bobbin thread is almost empty. When the
bobbin thread is nearly empty, the machine
automatically stops. However, if the “Start/
Stop” button is pressed, a few stitches can
be sewn. When the warning displays, re-
thread the machine immediately.
CAUTION
• Do not allow fabric pieces and dust to collect
in the foot controller. Doing so could cause a
fire or an electric shock.
fire or an electric shock.
Memo
• When the multi-function foot controller is
being used, you cannot start sewing by
pressing the “Start/Stop” button.
pressing the “Start/Stop” button.
• The multi-function foot controller cannot be
used when embroidering.
• The multi-function foot controller can be
used for sewing utility and decorative
stitches when the embroidery unit is
attached.
stitches when the embroidery unit is
attached.