Brother PR1000e Guía De Operación
If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering 115
3
—————————————————————————————————————————————————————————————————————————————————————
If the Thread Breaks or the Bobbin Thread Runs Out
While Embroidering
While Embroidering
If the thread breaks or the bobbin thread runs out while embroidering, the machine will automatically stop.
Since some stitches may be sewn with only one thread, go back through the stitching to a point where
stitches have already been sewn before continuing embroidering.
Since some stitches may be sewn with only one thread, go back through the stitching to a point where
stitches have already been sewn before continuing embroidering.
Note
● If the thread sensor is turned off, the
machine does not stop until embroidering
is finished. Normally, the thread sensor
should be turned on. (Refer to page 230.)
is finished. Normally, the thread sensor
should be turned on. (Refer to page 230.)
● Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
frame moves at the same time.
Memo
● When the thread breaks or the bobbin
thread runs out while embroidering, the
spool stand LEDs flash to notify you of the
problem.
spool stand LEDs flash to notify you of the
problem.
If the upper thread breaks
1
Re-thread the upper thread. (Refer to
page 56.)
page 56.)
2
Touch .
X
The stitch navigating screen appears.
3
Touch
to check the needle drop
point on the LCD screen.
X
The camera view window appears.
• Touch
to zoom up the camera view
twice the size of normal view.
4
Touch
and
to go back
through the stitching to a point where
stitches have already been sewn.
stitches have already been sewn.
1 Each touch of this key moves one stitch back
through the stitching.
2 Each touch of this key moves ten stitches back
through the stitching.
1
2