Brother PE-DESIGN NEXT Manual De Instrucciónes
22
Understanding Windows
Specifying Basic Software Settings
Adjusting on-screen
measurements
(Screen Calibration)
measurements
(Screen Calibration)
Measurements can be adjusted so that objects will
be displayed at the same size as the actual
embroidery at a zoom ratio of 100%. Once this
adjustment is made, it will not need to be done again
later.
be displayed at the same size as the actual
embroidery at a zoom ratio of 100%. Once this
adjustment is made, it will not need to be done again
later.
1.
Click 1, then 2.
2.
Click Screen Calibration (1). Hold a ruler
against the screen to measure the length of 2.
Next, enter the value at 3, and then click OK
(4).
against the screen to measure the length of 2.
Next, enter the value at 3, and then click OK
(4).
Be sure to enter the length in millimeters. A
value in inches is invalid.
value in inches is invalid.
System unit
1.
Click System Unit, and then select the
desired measurement units (mm or inch).
desired measurement units (mm or inch).
1
2
4
1
3
2
XE8656-001.book Page 22 Monday, May 24, 2010 5:44 PM