Brother RJ-2140 Guía De Referencia
Raster Command Reference
- 15 -
4. Print Data
4.3.3 Feed amount
The feed amount (left and right margins) is defined below.
Type
Minimum Margin Setting
Maximum Margin Setting
Continuous length tape
3.0 mm
0.12"
24 dots
0.12"
24 dots
127.0 mm
5"
1015 dots
5"
1015 dots
Die-cut labels
The length offset indicated in
“(b) Die-cut labels” of “
is used.
However, set
However, set
“0” as the value of the “specify margin amount”
command.
4.3.4 Maximum and minimum lengths
The maximum and minimum lengths are defined below.
Type
Minimum Length
Maximum Length
Continuous length tape
12.0 mm
0.47
0.47
”
96 dots
1000.0 mm
39.37
39.37
”
7992 dots
Die-cut labels
Fixed
Fixed
4.3.5 Maximum/minimum length of print area
The maximum/minimum lengths of the print area are defined below.
(These indicate the maximum and minimum lengths possible for the print area.)
Depending on the actual feed and length settings specified, the maximum and minimum lengths may
vary within the range of values in the following table.
Type
Minimum Length
Maximum Length
Continuous length tape
0.1 mm
0.01
0.01
”
1 dot
994.0 mm
39.13
39.13
”
7944 dots
Die-cut labels
Fixed
Fixed