Samsung AS24UUQ Manual De Usuario

•   Connect the power cable to the auxiliary circuit breaker. If every pole fails to connect to 

the power supply, it must be incorporated in a wire with a contact opening of ≥3 mm.

1) For electrical and earth works, comply with the ‘technical standards of electrical installations’ and the 

2) Tighten the terminal block screw to under 1.2 N.m (12 kgf.cm). 
3) Precautions when connecting terminal blocks of the indoor unit

 Before connecting, make sure the connecting part of the terminal socket is facing upwards.

 There must be no space between the terminal and the screw when connected.

the ‘wiring regulations’ of the Electricity Enterprises Act.

 

 

                    

 

   

 

 

   

 

 

   

Upside down

There is no ring terminal
to cover the wire.

The terminal socket

is damaged.

•   For the terminal block wiring, use a wire with a ring terminal socket only.

ng work.

The terminal socket

or there is a space between the screw

and the ring terminal.

is upside down.





1 Extend the assembly cable if necessary.
2 Open the front grille.
3 Remove the screw securing the connector cover.
4 Pass the assembly cable through the rear of the indoor unit and connect the

assembly cable to terminals as seen in the picture.

5 Pass the other end of the cable through the 65mm hole in the wall.
6 Close the connector cover, tightening the screw carefully.
7 Close the front grille.
8 Remove the terminal board cover on the side of the outdoor unit.

•   Each wire is labeled with the corresponding terminal number.

AS09**
AS12**

AS18**

AS24**

3G, 1.0 mm

2

3G, 1.5 mm

2

3G, 2.5 mm

2

3G, 1.0 mm

2

2

3G, 1.5 mm

2

3G, 2.5 mm

2

3G, 1.0 mm

2

3G, 1.0 mm