Samsung Freestanding Gas Ranges (NX58K9500 Series) Guía De Instalación

ADJUSTINg THE OVEN BURNER AIR ADJUSTMENT 

SHUTTERS

All oven burners have an air adjustment 

shutter. The purpose of the shutter is 

to regulate the flow of air to the flames. 

Properly adjusted flames should burn 

steadily with approximately 1-in of blue 

cone. The flames should never extend 

past the edge of the burner baffles. Even 

though these are preset at the factory, they 

should be checked and, if needed, adjusted 

periodically to ensure efficient operation.

To check and adjust the oven burner air adjustment 

shutters:

1.  Open the oven door.
2.  Remove the oven racks.
3.  Remove the oven floor.
4.  Press the Bake button, then the START/SET.
5.  After the oven has lit, visually check the flames coming out of the upper and 

lower burners. If adjustment is needed, carefully adjust the air adjustment 

shutters.

The shutters are located at the base of the burner manifolds near the back oven 

wall.

To adjust the shutter, loosen the locking screw 

and rotate the shutter towards the open or closed 

position as needed. If flames are lifting off the burner 

ports, gradually reduce the air shutter opening until 

the flames are stabilized.

If flames are too yellow and/or too large, gradually 

increase the air shutter opening until the flames have 

approximately a 1-in blue cone.

If the range is set up for natural gas, the flames should burn with no yellow 

tipping. If the range is set up for LP gas, small yellow tips at the end of the 

cones are normal.

After the flames are adjusted properly, shut off the 

oven, retighten the locking screws, replace the oven 

bottom and racks, and close the oven door.

Locking screw

Locking screw

Air 

adjustment 

shutter

Air 

adjustment 

shutter