Samsung HW-F551 Manual De Usuario

functions

Anynet+ is a function that enables you to control other Samsung Devices with 
your Samsung TV's remote control.

The Anynet+ function turns on and off each time you press Anynet+.

1. Connect the product to a Samsung TV with an the HDMI cable. 

(See page 13)

2. Set the Anynet+ function on your TV and the SAT to ON. (See the TV 

instruction manual for more information.)

 

Depending on your TV, certain HDMI output resolutions may not work.

 

Please refer to the user’s manual of your TV and check for the

 

logo (If your TV has an

 logo, then it supports the Anynet+ 

function.)

• Press TV SOURCE on the remote control to change the TV's input source.
• Press TV INFO on the remote control to display the TV channel information.
• Press TV CH on the remote control to select the TV channel.
• Press TV VOL on the remote control to increase or decrease the volume 

level.

• Use TV PRE-CH button to move to the previous TV channel in TV mode.
•  To exit the TV menu, use the TV EXIT button. (It functions the same as the 

EXIT button of the TV remote control.) 

 

When you press the SoundShare button, the TV's sound is  
transmitted through the Air Track system via a Bluetooth 
connection. The Air Track also controls the sound volume, sound 
quality, etc.

 

The remote control can operate TVs made by SAMSUNG only.

SOFTWARE UPGRADE

Samsung may offer upgrades for the Crystal Surround Air Track's system 
firmware in the future.

If an upgrade is offered, you can upgrade the firmware by connecting a 
USB drive with the firmware upgrade stored on it to the USB port on your 
Air Track.

Note that if there are multiple upgrade files, you must load them onto the 
USB drive singly and use them to upgrade the firmware one at a time.

Please visit Samsung.com or contact the Samsung call centre to receive 

more information about downloading upgrade files.

 

Insert a USB drive containing the firmware upgrade into the USB port on the main unit.

 

Do not disconnect the power or remove the USB drive while upgrades are being applied. The main unit will turn 
off automatically after completing the firmware upgrade.
When software is upgraded, settings you have made will return to their default (factory) settings. 
We recommend you write down your settings so that you can easily reset them after the upgrade.

 

Once upgrading the product software is completed, turn off the product and then press and hold () button for a while 
to reset the product.

 

If the firmware fails to upgrade, we recommend formatting the USB device in FAT16 and trying again.

 

For upgrading purposes, do not format the USB drive in NTFS format because it is not a supported file system.

 

Depending on the manufacturer, some USB devices may not be supported.