Samsung Електрична Варочна поверхня NZ-5000H із зоною Flex Zone, 7,2 кВт Manual De Usuario

English - 10

installing the hob

WARNING

Be sure the new appliance is installed and grounded only by

qualified personnel.

Please observe this instruction. The warranty will not cover any

damage that may occur as a result of improper installation.

Technical data is provided at the end of this manual.

SAFETY INSTRUCTIONS FOR THE INSTALLER

• A device must be provided in the electrical installation that allows

the appliance to be disconnected from the mains at all poles with a

contact opening width of at least 3 mm. Suitable isolation devices

include line protecting cut - outs, fuses (screw type fuses are to be

removed from the holder), earth leakage trips and contactors.

• With respect to fire protection, this appliance corresponds to EN

60335 - 2 - 6. This type of appliance may be installed with a high

cupboard or wall on one side.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is fitted must satisfy the

stability requirements of DIN 68930.

• For protection against moisture, all cut surfaces are to be sealed

with a suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits

must be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action springs

must be bonded in place with a suitable artificial resin or mixed

adhesive.

• Ensure that the seal is correctly seated against the work surface

without any gaps. Additional silicon sealant must not be applied;

this would make removal more difficult when servicing.

• The hob must be pressed out from below when removed.

• A board can be installed underneath the hob.

• The ventilation gap between the worktop and front of the unit

underneath it must not be covered.

NZ64H57479K_WT_DG68-00562A-01_EN.indd 10

2014-07-11 10:58:19