Zebra 01407-000 Manual De Usuario
45
Programming
Software Command Syntax
03/03/2009
TTP 1020™/TTP 1030™ Technical Manual
P1003643-001
Prints data from the input buffer and feeds the paper to the top of the next page.
In fixed document length (FORM-mode) this command prints data in the input buffer and
feeds the paper to the top of next page.
feeds the paper to the top of next page.
In variable document length mode this command acts as CR/LF.
In black-mark mode, the printer interprets incoming FF commands as ESC X 08 00
If Autocut at FF is set to 1 (in start-up parameter setting ESC & P n15), FF affects both form-
feed, cut, and eject.
The value n represents the number of dot lines (0.125 mm) the paper is to be transported
forwards. Maximum value for n = 255, equal to approximately 32 mm.
forwards. Maximum value for n = 255, equal to approximately 32 mm.
The value n represents the number of dot lines (0.125 mm) the paper is to be transported
backwards. Maximum value for n = 255, equal to approximately 32 mm.
backwards. Maximum value for n = 255, equal to approximately 32 mm.
FF
Form Feed
0C
hex
012
decimal
Note •
Use ESC C n1 n2 to define page length.
ESC J
n
Paper advance*
*.
DO NOT use ESC J n or ESC j n in fixed page mode
1B
4A
n
hex
027
074
n
decimal
ESC j
n
Paper reverse
1
1B
6A
n
hex
027
106
n
decimal
ESC V
n
Print speed adjustment
1B
56
n hex
027
086
n decimal
n
specifies the printing speed. The main reason to decrease the print speed is to
enhance print quality, and to reduce the peak current consumption.
enhance print quality, and to reduce the peak current consumption.
n = 19 Default value (maximum speed)
n = 1
Minimum speed
Note •
Some settings result in printer chassis resonance causing excessive noise and
deteriorated print quality.