Zebra 01407-000 Manual De Usuario
49
Programming
Software Command Syntax
03/03/2009
TTP 1020™/TTP 1030™ Technical Manual
P1003643-001
Sets the eject length of the receipt, that is the length of paper that protrudes outside the printer
after a cut command. This eject length should be 40-63 mm. Marks on the test receipt show
max and min eject length.
after a cut command. This eject length should be 40-63 mm. Marks on the test receipt show
max and min eject length.
Range 1–255. Default value when loading firmware is 40, but should be set individually from
printer to printer. The set value is shown in a line on the test printout.
printer to printer. The set value is shown in a line on the test printout.
After sending the command, wait until the presenter motor buzzes, and then make a self-test
printout to check if the set eject length is correct.
printout to check if the set eject length is correct.
This command resets the parameters of the printer to factory default.
Temporarily sets all parameters to predefined values that are stored in the printer. To keep the
values as default, store them in the parameter memory with command ESC & 4.
values as default, store them in the parameter memory with command ESC & 4.
Unless you save the parameters, a reset command or power OFF/ON will return the
parameters to the settings stored in the parameter memory.
parameters to the settings stored in the parameter memory.
The firmware in the printer holds various parameter values called default parameters. One or
several of them can be overridden temporarily with this command.
several of them can be overridden temporarily with this command.
.
The permanently stored parameters will be used again after a printer-reset command or at
power ON.
power ON.
In TTP 1030 the temporary values can, however, be stored as permanent values with command
ESC & 4.
ESC & 4.
This command should only be used when loading new firmware into the printer. See also
ESC & 6
Calibrate eject length*
*.
Added in firmware version 2.18
1B
26
06 Hex
027
038 006 Decimal
ESC &
F
Recall factory default parameters
1B
26
46 hex
027
038
070 decimal
ESC & P n V
Set parameter value
1B
26
50
n
v hex
027
038 080
n
v decimal
n
Parameter number
v Parameter
value.
ESC
NUL
Load firmware
1B
00
hex
027
000
decimal