Samsung SNC-L200N Manual De Usuario

➀ 

Push downward and remove the cover located at the back of Netcam.

➁

Connect one end of the Ethernet cable to the router.

➂

Connect the other end of the Ethernet cable to the back of Netcam.

➃

Connect the power adapter and power cable to the power outlet and then connect
them to the back of Netcam.

➄

After the power is connected for 1 minute, make sure Netcam lens automatically
moves.

➅ 

Close the cover at the back of Netcam.

1.  Drill two holes (Diameter: 5 mm, Depth: 35 mm) on the installation location using an

electric driller. Vertical distance between the two holes should be 35 mm.

* It would be convenient for you to stick the enclosed label template on the

installation surface and use it.

2.  Insert the enclosed two plastic anchors to the holes (one each) and tighten the

screws with a driver.

*  To install on a regular wooden wall, refer to the figure above and tighten two screws

with a driver.

3.  Remove the cover from the back of the SET. Plug in LAN-CABLE and POWER

CORD. Align the two to the groove of the cover, and then close the cover as shown
in the figure below. 

Install directly on the wall or on let it stand on a flat surface as a tabletop type.
You may install it where you want by using separate stands, such as wall mount.
(However, when using supplementary stands such as a wall mount to install, make sure the
stand can be secured to the nuts on the back of the SET.

* 

- When installing on the wall, make sure the location can withstand more than the SET

weight (app. I kg).

- There is a falling hazard after the SET is installed on the wall. Make sure nobody comes

close to it.

- The SET is intended or indoor use. Install it in a place where it cannot be reached by

rain, water, or with less humidity.

- When installing using a fixed type stand and separate structures, make sure to secure

them so they do not become loose from the nuts on the back of the SET.

35mm

Depth 35mm Minimum

(for Plastic 

Anchor)

34mm

Ø5mm 2 Hole

4.  Align two grooves at the back of the SET to the pre-installed screws on the wall

and hang the SET. Pull it slightly downward. The installation is complete.