ICOM IC-U82 Manual De Usuario

39

10

PAGER/CODE SQUELCH

D

D

Your ID code MUST be programmed into code channel C0.
Up to 6 transmit codes (codes that you transmit) are pro-
grammable into code channels, C1 to C6, if required.

q

Push [A•

], then push [0•

] to enter 

OPTION SET

MODE

.

• Rotate [VOL] to select “dtm.PG” or “dtm.CS,” if “dtm.OF” ap-

pears.

w

Push and hold [0•

] for 1 sec. to enter the code selec-

tion mode.

• One of either “CP” or “C0” to “C6” blinks.
• “C0” is your ID code and “C1” to “C6” are transmit codes.

e

Rotate [VOL] (or push [

Y

Y

]/[

Z

Z

]) to select code channel C0.

• Each transceiver should have a different ID code.

r

Enter the desired 3-digit ID code via the keypad.

t

Rotate [VOL] (or push [

Y

Y

]/[

Z

Z

]) to select a transmit code

channel from C1 to C6. 

y

Enter the desired 3-digit transmit code via the keypad.

u

Push [A•

], then push [6•

] to set the channel to

“receive inhibit” or “receive accept.”

• When “receive inhibit” is set, “SKIP” appears as below.
• Code channel C0 cannot be set as “receive inhibit.”
• See the table for “receive accept” and “receive inhibit” details

(p. 38).

i

Repeat steps 

t

and 

y

to set additional transmit code

channels, if desired.

o

Push [

✱

] or [PTT] to exit code selection mode.

➥

“Receive accept” (“SKIP” indicator does not appear) ac-

cepts pager calls when the transceiver receives a signal
with a code the same as that in the code channel.

➥

“Receive inhibit” (“SKIP” indicator appears) ignores calls

even when the transceiver receives a code the same as
that in the code channel. Transmit codes should therefore
be programmed for “receive inhibit,” otherwise the trans-
ceiver will not reject unnecessary calls.

or