Acer g3620-044 Manual De Usuario
5 Upgrading your computer
28
English
To install a memory module:
Note: DIMM slots on the mainboard must be installed only in certain
configurations. Numbers next to DIMM slots correspond to installation
sequence. DIMMs may be installed in pairs and in the correct order.
configurations. Numbers next to DIMM slots correspond to installation
sequence. DIMMs may be installed in pairs and in the correct order.
1
Perform steps 1 and 2 of the previous section.
2
Select an empty DIMM slot.
3
Open the holding clips on the DIMM slot.
If you are replacing an existing DIMM, install the new DIMM in the same slot
where you removed the DIMM.
where you removed the DIMM.
If you are adding a new DIMM, note that the system supports dual channel
configuration. The total size of the DIMMs installed in the channel A slots must
match the total size of the DIMMs in channel B slots.
configuration. The total size of the DIMMs installed in the channel A slots must
match the total size of the DIMMs in channel B slots.
4
Remove the new DIMM from its protective packaging, handling it by the
edges.
edges.
5
Align the DIMM so that the notch on the slot fits the keyed edge of the module,
then press the module at both ends to seat it fully into the slot (1).
then press the module at both ends to seat it fully into the slot (1).
If you insert a DIMM but it does not fit easily into the slot, you have inserted it
incorrectly. Reverse the orientation of the module and insert it again.
incorrectly. Reverse the orientation of the module and insert it again.
6
Firmly press the holding clips inward to lock the DIMM in place (2).
If the holding clips do not close, the DIMM is not properly inserted.
7
Observe the post-installation instructions described on page 23.
The system automatically detects the amount of memory installed. Run the
BIOS setup to view the new value for total system memory and make a note of
it.
BIOS setup to view the new value for total system memory and make a note of
it.