Alesis studio24 Manual De Usuario
Recording
5 2 S
TUDIO
24 R
EFERENCE
M
ANUAL
The Studio 24 has been designed with plenty of headroom on the internal summing
amplifiers (23 dB of headroom above a +4 dBu balanced output level). It is only
possible to clip the mixer internally if several channels are at or near their maximum
clipping point (with PEAK indicators flashing) and then sent at maximum gain to an
output. You are in danger of this if:
amplifiers (23 dB of headroom above a +4 dBu balanced output level). It is only
possible to clip the mixer internally if several channels are at or near their maximum
clipping point (with PEAK indicators flashing) and then sent at maximum gain to an
output. You are in danger of this if:
•
the meter is hitting the top of its range (“PK”) with the GROUP MASTER
FADER set to nominal level, or
FADER set to nominal level, or
•
the GROUP or MASTER FADER is set to -20 or lower, and the MASTER LED
Meter is reading 0 dB or above.
Meter is reading 0 dB or above.
Once again, it may be necessary to decrease either the TRIM control, the Channel
FADERS, or both, of each of the Channels assigned to the Group.
FADERS, or both, of each of the Channels assigned to the Group.
Maintain Proper System Levels
As a good rule of thumb, try to run most volume level controls of other equipment
receiving signal from the Studio 24 (amplifiers, effect devices) at 3/4 or 75% of full, as
well. This will decrease the possibility of overload distortion and keep the amount of
background noise to a minimum.
As a good rule of thumb, try to run most volume level controls of other equipment
receiving signal from the Studio 24 (amplifiers, effect devices) at 3/4 or 75% of full, as
well. This will decrease the possibility of overload distortion and keep the amount of
background noise to a minimum.