Alesis studio24 Manual De Usuario
Recording
6 4 S
TUDIO
24 R
EFERENCE
M
ANUAL
To bounce multiple tracks to two tracks (stereo):
1
For each Channel (tape track) you wish to bounce, press the CHAN/MON
REVERSE button so it is down.
This sends the tape tracks to the Channel FADERS.
REVERSE button so it is down.
This sends the tape tracks to the Channel FADERS.
Make sure that CHAN/MON REVERSE is UP on the Channels you’re
bouncing to (Channels 5 and 6 in this example). Otherwise, feedback
may occur.
bouncing to (Channels 5 and 6 in this example). Otherwise, feedback
may occur.
2
Assign the Channels to Groups 1 and 2 by pressing the GRP buttons next to the
channel faders.
channel faders.
3
Raise the GRP 1 and 2 FADERS to the maximum position.
4
Place tracks 5 and 6 into record-ready, and select either GRP 1/2 or MON 1/2 as
the Control Room source. If you’re using MON 1/2, turn the monitor pan (the
upper black knob, not the one close to the MUTE key) for track 5 hard left, and
the monitor pan for track 6 hard right.
the Control Room source. If you’re using MON 1/2, turn the monitor pan (the
upper black knob, not the one close to the MUTE key) for track 5 hard left, and
the monitor pan for track 6 hard right.
5
Set the DIRECT OUT SOURCE switch of Channels 5 and 6 to its GRP (down)
position.
position.
6
Adjust each Channel’s PAN knob and FADER to achieve a desirable mix.
7
Rewind the tape, and record onto tracks 5 and 6 those portions you wish to
bounce.
bounce.
8
Tracks 1-4 are now available for recording new parts.