Axis 25221r3 Manual De Usuario

AXIS COMMUNICATIONS

<Product Name> Quick User’s Guide

This manual is intended for administrators and users of the 

AXIS 262 Network Video Recorder. It includes instructions 

for using and managing the AXIS 262 on your network. 

Previous experience of networking will be of use when 

installing and using this product. Later versions of this 

document will be posted to the Axis Website, as required. 

See also the product’s online help, available via the 

Web-based interface.

Caution! - Indicates a potential hazard that can damage the 

product.

Important! - Indicates a hazard that can seriously impair 

operation.

Do not proceed beyond any of the above notices until you 

have fully understood the implications.

This product contains licensed third-party software. See the 

menu item “About” in the product’s user interface for more 

information.

Video recording can be prohibited by laws that vary from 

country to country. Check the laws in your local region 

before using this product for surveillance purposes. 

This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful 

interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or 

more of the following measures: Re-orient or relocate the 

receiving antenna. Increase the separation between the 

equipment and receiver. Connect the equipment to an 

outlet on a different circuit to the receiver. Consult your 

dealer or an experienced radio/TV technician for help. 

Shielded (STP) network cables must be used with this unit 

to ensure compliance with EMC standards.

This digital equipment fulfills the 

requirements for radiated emission according to limit B of 

EN55022/1998, and the requirements for immunity 

according to EN55024/1998 residential, commercial, and 

light industry.

This is a class B product based on the standard of 

the Voluntary Control Council for Interference from 

Information Technology Equipment (VCCI). If this is used 

near a radio or television receiver in a domestic environment, 

it may cause radio interference. Install and use the equipment 

according to the instruction manual. 

Every care has been taken in the preparation of this 

manual; Please inform your local Axis office of any 

inaccuracies or omissions. Axis Communications AB 

cannot be held responsible for any technical or 

typographical errors and reserves the right to make changes 

to the product and manuals without prior notice. Axis 

Communications AB makes no warranty of any kind with 

regard to the material contained within this document, 

including, but not limited to, the implied warranties of 

merchantability and fitness for a particular purpose. Axis 

Communications AB shall not be liable nor responsible for 

incidental or consequential damages in connection with the 

furnishing, performance or use of this material. Axis 

Communications AB cannot be held responsible for any data 

loss in the event of a hard disk failure.

Please observe the following when using the AXIS 262:

• Operate this unit at the correct voltage (12V DC), using other 

voltages may cause fire or electrical shock. 

• The use of UPS is highly recommended.

• This AXIS 262 is a precision machine. Please handle this unit 

with care. Vibration and shock could damage the unit so 

please use the original packaging if moving the AXIS 262. 

• Wait 30 seconds before moving the AXIS 262 after 

disconnecting the power supply to avoid damaging the hard 

disk.

• Exposure to water or moisture may cause fire or electrical 

shock. If water gets inside the unit, disconnect it immediately 

and contact your dealer.

• Please disconnect the power supply cable if the power supply 

has been turned off.

• Do not open the cover or touch the internal components. 

• Do not use or set the unit where it might be exposed to 

vibrations or shocks; direct sunlight, rain or snow; flammable 

or corrosive gas; extreme hot or cold temperatures; humid or 

dusty conditions; strong electric shock and magnetic fields.

• To extend the lifetime of the unit, keep the operating 

temperature below 40ºC.

• If the temperature is below 0ºC, the unit must be turned on at 

all times.

Internet Explorer, LAN Manager, Linux, Microsoft, UNIX, 

Windows, WWW are registered trademarks of the respective 

holders. Java and all Java-based trademarks and logos are 

trademarks or registered trademarks of Sun Microsystems, Inc. 

in the United States and other countries. Axis Communications 

AB is independent of Sun Microsystems Inc. 

Should you require any technical assistance, please contact 

your Axis reseller. If your questions cannot be answered 

immediately, your reseller will forward your queries through 

the appropriate channels to ensure a rapid response. If you are 

connected to the Internet, you can:

• download user documentation and firmware updates

• report problems to Axis support staff by logging in to your 

private support area

• visit the Axis Support Web at www.axis.com/techsup/

The AXIS 262 uses a 3.0V CR2032 Lithium battery as the power 

supply for its internal real-time clock (RTC). Under normal 

conditions this battery will last for a minimum of 3 years. Low 

battery power affects the operation of the RTC, causing it to 

reset to 2003/1/1 at every power-up.

The battery should not be replaced unless required!

If the battery does need replacing, please observe the following:

• Danger of Explosion if battery is incorrectly replaced.

• Replace only with the same or equivalent battery, as 

recommended by the manufacturer.

• Dispose of used batteries according to the manufacturer's 

instructions.

AXIS 262 User’s Manual

Revision 1.0, March 2006

Part No: 25221r2

Copyright© Axis Communications AB, 2005