applied-energy selectronic Manual De Usuario

8

The installation should be done by qualified personnel and checked by the electricity supply authority.

We recommend that the installation be done in the following sequence:–
a)  Fix the shower to the wall
b) Plumbing
c) Electrical 

connections

d) Commissioning

When deciding where to place the unit a few things need to be taken into consideration: -

1) The 

unit 

must not be mounted directly in the path of the spray from the handset.

2)  The handset could be used over a sink for hair washing.

3)  The handset does not come into contact with 

the used water in the cubicle, bath or basin.
A hose retainer is supplied with the 
accessories (see fig 16 & 17).

4)  The unit can be mounted at a lower level 

for less able users combined with optional 
extended hose and riser rail. The installation
must comply with BS 8300: 2001.
(Design of buildings and their approaches
to meet the needs of disabled people.
Code of practice). Remembering to adhere 
to point 1.

5)  Choose a flat piece of wall to avoid the 

possibility of distorting the backplate and 
making the front cover a poor fit.

Remove the three cover screws and lift the 
shower cover off.

Remove side section complete with seal.
Depending on which water entry is being used 
(top or bottom) break out the relevant rear 
support rib using a pair of pliers (see fig 12).

Identify which pipe and cable entry needs to be 
cut to enable the services to enter the shower 
(top or bottom, no trimming required for rear entry) 
then fit them to the backplate (see fig 12).

Hold the shower vertically against the wall and 
mark the top hole first.

Drill the hole to take the rawl plug provided 
(taking care to keep dust away from the shower).

Put the top screw in first leaving it proud by 
5mm approx. The shower can now be hung on 
this screw.