Apogee x-digi-mix card Manual De Usuario
APOGEE ELECTRONICS
3
X-Digi-Mix – User’s Guide
Installing the X-Digi-Mix Card
Your X-Digi-Mix card should include the following:
• 1 X-Digi-Mix circuit board
• 1 X-Digi-Mix Coverplate
• 2 aluminium standoffs,
• 1 plastic standoff
• 1 user’s guide
• 1 X-Digi-Mix Coverplate
• 2 aluminium standoffs,
• 1 plastic standoff
• 1 user’s guide
The procedure for installing the X-Digi-Mix card into an Apogee
Rosetta 800 is shown below:
Rosetta 800 is shown below:
1) Remove the top cover of the interface
2) Remove the Option Card coverplate and install the
2) Remove the Option Card coverplate and install the
X-Digi-Mix coverplate using the screws from the original
coverplate.
coverplate.
3) Remove the two interface circuit board screws as
indicated to the left, and set them aside for later use.
4) Install the two aluminium standoffs in the holes vacated
by the screws.
5) Install one end of the plastic standoff in the hole adjacent
to the connector pins of the X-Digi-Mix card: install the
other end in the hole adjacent to the mating connector.
other end in the hole adjacent to the mating connector.
6) Insert the BNC/Peripheral connector end of the X-
Digi-Mix card through the appropriate cutouts in the
coverplate, and carefully place the X-Digi-Mix connector
pins in the mating interface connector.
coverplate, and carefully place the X-Digi-Mix connector
pins in the mating interface connector.
7) After verifying the alignment of the X-Digi-Mix connector
pins and the interface mating connector, firmly press
down on the X-Digi-Mix card, over the connector, until
the pins are completely seated in the mating connector.
down on the X-Digi-Mix card, over the connector, until
the pins are completely seated in the mating connector.
8) Re-install the circuit board screws in the locations
indicated below.
2
3
6
8
Plastic standoff here