Asrock 880g extreme3 Manual De Usuario

3 3

3 3

3 3

3 3

3 3

+5V

DUMMY

DUMMY

SPEAKER

1

Chassis and Power Fan Connectors

Please connect the fan cables

(3-pin CHA_FAN1)

to the fan connectors and

(see p.11  No. 9)

match the black wire to the
ground pin. CHA_FAN1/2/3 fan

(3-pin CHA_FAN2)

speed can be controlled through

(see p.11  No. 11)

BIOS or OC Tuner utility.

(3-pin CHA_FAN3)
(see p.11  No. 12)

(3-pin PWR_FAN1)
(see p.11  No. 5)

Chassis Speaker Header

Please connect the chassis

(4-pin SPEAKER 1)

speaker to this header.

(see p.11  No. 20)

Power LED Header

Please connect the chassis

(3-pin PLED1)

power LED to this header to

(see p.11  No. 19)

indicate system power status.
The LED is on when the system
is operating. The LED keeps
blinking in S1 state. The LED is
off in S3/S4 state or S5 state
(power off).

1

PLED+

PLED+

PLED-

GND

PWRBTN#

PLED-

PLED+

DUMMY

RESET#

GND

HDLED+

HDLED-

1

System Panel Header

This header accommodates

(9-pin PANEL1)

several system front panel

(see p.11  No. 21)

functions.

GND
+12V

CHA_FAN_SPEED

FAN_SPEED_CONTROL

GND
+12V
CHA_FAN_SPEED

GND
+12V

CHA_FAN_SPEED

PWR_FAN_SPEED

GND

+12V

1. High Definition Audio supports Jack Sensing, but the panel wire on
    the chassis must support HDA to function correctly. Please follow the

 instruction in our manual and chassis manual to install your system.

2. If you use AC’97 audio panel, please install it to the front panel audio
    header as below:
    A. Connect Mic_IN (MIC) to MIC2_L.
    B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.

 C. Connect Ground (GND) to Ground (GND).

    D. MIC_RET and OUT_RET are for HD audio panel only. You don’t
         need to connect them for AC’97 audio panel.
    E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select

      Chipset Configuration. Set the Front Panel Control option from
      [Auto] to [Enabled].