autotech 10.215.455k Manual De Usuario

A

U

T

O

T

E

C

H

Installation Instructions

Phone 714.240.4000   Fax 714.240.0450

32240-E Paseo Adelanto, San Juan Capistrano,  CA  92675

Part Number: 10.215.455K

Description:  Sport Tuned Boost Check Valve

Procedure:

1.  Open hood and locate the air hose leading from the idle stabilizer to the bypass tube.

2.  Measure 1 1/4" from the idle stabilizer end of the hose and mark.  Next, make another

mark 5" from the same starting point.

3.  Cut the hose at both marks, and remove the 3 1/4" section of hose that has just been

cut out.  The boost check valve will replace the section of hose that you have just cut out.

4.  Loosen the hose clamps a little and place them over the hose at both ends.  Insert the

boost check valve into both ends of the hose, with the arrow on the check valve body point-

ing towards the idle stabilizer.

5.  Slide both hose clamps over the hose, approximately 1/4" away from the flats on the

black anodized ends of the check valve.  Tighten both hose clamps.

5"

Mark and Cut

3 1/4"

1 1/4"

Remove This Piece

á