3com 3CRWE850075A Manual De Usuario
20
1
Install the mounting plate as shown in the following illustration, on either a stud
(or other hard wall surface), or onto drywall.
(or other hard wall surface), or onto drywall.
n
Allow for a clearance of at least 25 cm (10 Inches) between the ceiling and the
top of the mounting plate.
n
Make sure that “UP” is correctly oriented, and align the mounting plate screw
holes vertically.
n
For installation on a wall stud, install the top screw into the stud, as shown at
left in the illustration, and then vertically align the mounting plate before
installing the bottom screw.
n
For installation on to drywall, mark three screw holes using the mounting plate
as a template for vertical alignment, as shown at right in the illustration above.
n
Use a 5-mm (3/16-in.) drill bit if using the plastic anchors provided.
n
For drywall mounts, you can route the cable through either a side or center
opening for a seamless appearance using one of the methods illustrated below.
Alternatively, you can simply attach the Ethernet cable to the side of the unit,
allowing it to trail along the wall.
n
If you have routed the Ethernet cable through the center opening, secure the
cable on the hook located on the mounting plate as shown in the illustration
below.
2
Connect the Ethernet cable to the Ethernet port on the access point.
If installing into drywall, use
3 plastic anchors and 3 screws.
3 plastic anchors and 3 screws.
If installing into a stud or other
secure vertical surface, use 2 screws.
secure vertical surface, use 2 screws.