3com WX4400 3CRWX440095A Manual De Usuario

C

HAPTER

 10: C

ONFIGURING

 MAP A

CCESS

 P

OINTS

Although these parameters have default values, 3Com recommends that 
you change the values for each radio for optimal performance. For 
example, leaving the channel number on each radio set to its default 
value can result in high interference among the radios.

(To configure these parameters, see “Configuring Radio-Specific 
Parameters” on page 246.)

For most MAP models, the 
default is internal.

For MP-620, the default for the 
802.11b/g radio is 
ANT-1360-OUT. The default for 
the 802.11a radio is 
ANT-5360-OUT.

The default for the 802.11b/g 
radio on model MP-262 is 
ANT1060.

3Com external antenna model

This parameter is configurable 
only on MAPs that support 
external antennas.

Highest setting allowed for the 
country of operation or highest 
setting supported on the 
hardware, whichever is lower

Maximum percentage of client 
retransmissions a radio can 
experience before RF 
Auto-Tuning considers changing 
the channel on the radio.

(To configure RF Auto-Tuning, 
see “Configuring 
RF Auto-Tuning” on page 311.)

„

802.11b/g — 6

„

802.11a — Lowest valid 
channel number for the 
country of operation

Number of the channel in which 
a radio transmits and receives 
traffic

Operational state of the radio.

None. You must add the radios 
to a radio profile.

802.11 settings 

Highest setting allowed for the 
country of operation or highest 
setting supported on the 
hardware, whichever is lower. 

Transmit power of a radio, in 
decibels referred to 1 milliwatt 
(dBm)

Table 13   Radio-Specific Parameters (continued)