3com WX4400 3CRWX440095A Manual De Usuario

C

HAPTER

 10: C

ONFIGURING

 MAP A

CCESS

 P

OINTS

Table 19   Transmit Rates

„

11a— 6.0,12.0,24.0

„

11b—1.0,2.0

„

11g—1.0,2.0,5.5,11.0

Set of data transmission rates that 
clients are required to support in order 
to associate with an SSID on a MAP 
radio. A client must support at least one 
of the mandatory rates. 

These rates are advertised in the basic 
rate set of 802.11 beacons, probe 
responses, and reassociation response 
frames sent by MAP radios.

Data frames and management frames 
sent by MAP radios use one of the 
specified mandatory rates.

The valid rates depend on the radio type:

„

11a—6.0, 9.0, 12.0, 18.0, 24.0, 
36.0, 48.0, 54.0

„

11b—1.0, 2.0, 5.5, 11.0

„

11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 
12.0, 18.0, 24.0, 36.0, 48.0, 54.0

Use a comma to separate multiple rates; 
for example: 6.0,9.0,12.0

None. All rates applicable 
to the radio type are 
supported by default.

Data transmission rates that MAP radios 
will not use to transmit data. This 
setting applies only to data sent by the 
MAP radios. The radios will still accept 
frames from clients at disabled data 
rates. 

The valid rates depend on the radio type 
and are the same as the valid rates for 
mandatory.

If you disable a rate, you cannot use the 
rate as a mandatory rate or the beacon 
or multicast rate. All rates that are 
applicable to the radio type and that are 
not disabled are supported by the radio. 

„

11a—6.0

„

11b—2.0

„

11g—2.0

Data rate of beacon frames sent by 
MAP radios. This rate is also used for 
probe-response frames. 

The valid rates depend on the radio type 
and are the same as the valid rates for 
mandatory. However, you cannot set 
the beacon rate to a disabled rate.