3com WX1200 3CRWX120695A Manual De Usuario
Working with Files
605
The tftp://ip-addr/filename URL refers to a file on a TFTP server. If DNS is
configured on the WX switch, you can specify a TFTP server’s hostname as
an alternative to specifying the IP address.
configured on the WX switch, you can specify a TFTP server’s hostname as
an alternative to specifying the IP address.
The tmp:filename URL refers to a file in temporary storage. You can copy
a file out of temporary storage but you cannot copy a file into temporary
storage.
a file out of temporary storage but you cannot copy a file into temporary
storage.
The subdirname/ option specifies a subdirectory.
If you are copying a system image file into nonvolatile storage, the
destination-url must include the boot partition name. You can specify one
of the following:
destination-url must include the boot partition name. You can specify one
of the following:
boot0:/filename
boot1:/filename
You must specify the boot partition that was not used to load the
currently running image.
currently running image.
The maximum supported file size for TFTP is 32 MB.
You can copy a file from a WX switch to a TFTP server or from a TFTP
server to a WX switch, but you cannot use MSS to copy a file directly
from one TFTP server to another.
server to a WX switch, but you cannot use MSS to copy a file directly
from one TFTP server to another.
To copy the file floor2wx from nonvolatile storage to a TFTP server, type
the following command:
the following command:
WX1200# copy floor2wx tftp://10.1.1.1/floor2wx
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
The above command copies the file to the same filename on the TFTP
server. To rename the file when copying it, type the following command:
server. To rename the file when copying it, type the following command:
WX1200# copy floor2wx tftp://10.1.1.1/floor2wx-backup
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
To copy a file named newconfig from a TFTP server to nonvolatile storage,
type the following command:
type the following command:
WX1200# copy tftp://10.1.1.1/newconfig newconfig
success: received 637 bytes in 0.253 seconds [ 2517
bytes/sec]
success: received 637 bytes in 0.253 seconds [ 2517
bytes/sec]