HP 5187-2725 Manual De Usuario
Updating to HP-UX 11i v2
Creating an HP Service Partition
Chapter 6
114
Step 5. Enter the appropriate Keyboard device for your system.
Step 6. The
Welcome to Ignite-UX!
screen appears. Using the
Tab
key, select
Advanced Options
. The
User Interface and Media Options
screen appears.
Step 7. From the list of User Interface Options, select
Advanced Installation
, then
select
OK
. The
/opt/ignite/bin/itool()
screen appears.
Step 8. From the
Basic
tab, select
Additional...
. The
Additional Configuration
Controls
screen appears. This screen includes a list of current partitions
and their sizes (in KB).
Step 9. Select
EFI Boot Partition
. A popup screen appears listing partition size
options (in KB) that you can choose from. Select
512000
(500 MB) from
the list and select
OK
. You should now be back in the
Additional
Configuration Controls
screen.
Step 10. Select
HP Service Partition
. Select
409600
(400 MB) from the list and
select
OK
.
Step 11. In the
Additional Configuration Controls
screen, select
OK
.
Step 12. In the
/opt/ignite/bin/itool()
screen select
Go!
Your system partitions (EFI
and HP Service Partition) have been configured and Ignite-UX will now
begin restoring your system data.
begin restoring your system data.
Step 13. If you backed up your user data using other backup software, restore this
data now following the vendor’s restore procedures.
Step 14. After your system and user data has been restored, run the
idisk
command again to verify that the HP Service Partition was created and
the partition size is correct.
the partition size is correct.