HP dl385 Manual De Usuario

 

Regulatory compliance notices  88 

Regulatory compliance notices 

Federal Communications Commission notice 

Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established Radio 
Frequency (RF) emission limits to provide an interference-free radio frequency spectrum. Many electronic 

devices, including computers, generate RF energy incidental to their intended function and are, therefore, 

covered by these rules. These rules place computers and related peripheral devices into two classes, A 

and B, depending upon their intended installation. Class A devices are those that may reasonably be 
expected to be installed in a business or commercial environment. Class B devices are those that may 

reasonably be expected to be installed in a residential environment (for example, personal computers). 

The FCC requires devices in both classes to bear a label indicating the interference potential of the device 

as well as additional operating instructions for the user. 

 

FCC rating label 

The FCC rating label on the device shows the classification (A or B) of the equipment. Class B devices 

have an FCC logo or ID on the label. Class A devices do not have an FCC logo or ID on the label. After 
you determine the class of the device, refer to the corresponding statement. 

 

Class A equipment 

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference when the equipment is operated in a commercial environment. This equipment generates, 

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. Operation of this equipment in a 

residential area is likely to cause harmful interference, in which case the user will be required to correct 
the interference at personal expense. 

 

Class B equipment 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can 

be determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures: 

•

 

Reorient or relocate the receiving antenna. 

•

 

Increase the separation between the equipment and receiver.