HP proliant bl e-class Manual De Usuario
Spanning Tree Protocol
Avoiding Trouble
Below are some tips for avoiding trouble.
Know Where the Root is Located
Although the STP can elect a root bridge, a well-designed network will have an identifiable
root for each VLAN. Careful setup of the STP parameters will lead to the selection of this
best interconnect switch as the root for each VLAN. Redundant links can then be built into
the network. STP is well suited to maintaining connectivity in the event of a device failure or
removal, but is poorly suited to designing networks.
root for each VLAN. Careful setup of the STP parameters will lead to the selection of this
best interconnect switch as the root for each VLAN. Redundant links can then be built into
the network. STP is well suited to maintaining connectivity in the event of a device failure or
removal, but is poorly suited to designing networks.
Know Which Links are Redundant
Organize the redundant links and tune the port cost parameter of STP to force those ports to
be in the blocking state.
be in the blocking state.
For each VLAN, know which ports should be blocking in a stable network. A network
diagram that shows each physical loop in the network and the ports that break each loop is
extremely helpful.
diagram that shows each physical loop in the network and the ports that break each loop is
extremely helpful.
Minimize the Number of Ports in the Blocking State
A single blocking port transitioning to the forwarding state at an inappropriate time can cause
a large part of a network to fail. Limiting the number of blocked ports helps to limit the risk
of an inappropriate transition.
a large part of a network to fail. Limiting the number of blocked ports helps to limit the risk
of an inappropriate transition.
Figure D-9: Example 1: A common network design
HP ProLiant BL e-Class C-GbE Interconnect Switch User Guide
D-13
HP CONFIDENTIAL Codename: DeLorean Part Number: 263682-002 Last Saved On: 2/5/03 10:46 AM