HP proliant bl e-class Manual De Usuario

Circumstances can occur where one address in the source/destination pair is a constant. For 
example, the destination might be a server or, even more likely, a router. In that case, if both 
the source address and destination address option is selected, you will still see statistical load 
balancing, because the source address is always different. 

The default four the interconnect switch is to use the source MAC address-based load 
balancing. This means that all packets the switch receives on a non-trunk port with the same 
source MAC address (SA), and that are destined to MAC addresses on the other side of the 
port trunk, will use the same link in the port trunk. Source-based forwarding should be used 
when many stations attached to the switch are sending to a few stations (such as a single 
router) on the other side of the port trunk. This better distributes traffic across all links in the 
port trunk. 

Also, switches maintain a notion of a "primary" port on which to transmit traffic such as 
Spanning Tree Protocol, multicasts, and unknown unicasts. The properties of this primary 
port determine the properties of how the port trunk works with features like Spanning Tree, 
VLAN, multicasting, and so on. 

By default, XConnects between Switch A and Switch B in the chassis form a port trunk 
“XConnect’ with two links, as shown in the following figure. 

 

With source-MAC address forwarding, when packets are forwarded to a port trunk, they are 
distributed across the ports in the port trunk based on the source-MAC address (SA) of the 
incoming packet. Therefore, to provide load balancing, packets from different hosts use 
different ports in the port trunk, but packets from the same host use the same port in the port 
trunk.  

With destination-MAC address forwarding, when packets are forwarded to a port trunk, they 
are distributed across the ports in the port trunk based on the destination host's MAC address 
(DA) of the incoming packet. Therefore, packets to the same destination are forwarded over 
the same port, and packets to a different destination are sent on a different port in the port 
trunk.