HP proliant dl380 Manual De Usuario

Descargar
Página de 113
 
Configuration and utilities  62 
Configuration Replication Utility 
ConRep is shipped in the SmartStart Scripting Toolkit and is a program that works with RBSU to replicate 
hardware configuration on ProLiant servers. This utility is run during State 0, Run Hardware Configuration 
Utility, when doing a scripted server deployment. ConRep reads the state of the system environment 
variables to determine the configuration and then writes the results to an editable script file. This file can 
then be deployed across multiple servers with similar hardware and software components. For more 
information, refer to the SmartStart Scripting Toolkit User Guide on the HP website 
(
 
HP ROM-Based Setup Utility 
RBSU, an embedded configuration utility, performs a wide range of configuration activities that may 
include: 
 
Configuring system devices and installed options 
 
Displaying system information 
 
Selecting the primary boot controller 
 
Configuring memory options 
 
Language selection 
For more information on RBSU, refer to the HP ROM-Based Setup Utility User Guide on the Documentation 
CD or the HP website (
 
Using RBSU 
The first time you power up the server, the system prompts you to enter RBSU and select a language. 
Default configuration settings are made at this time and can be changed later. Most of the features in 
RBSU are not required to set up the server. 
To navigate RBSU, use the following keys: 
 
To access RBSU, press the F9 key during power up when prompted in the upper right corner of the 
screen. 
 
To navigate the menu system, use the arrow keys. 
 
To make selections, press the Enter key. 
  
 
IMPORTANT:
  RBSU automatically saves settings when you press the Enter key. The utility does 
not prompt you for confirmation of settings before you exit the utility. To change a selected 
setting, you must select a different setting and press the Enter key. 
  
 
Auto-configuration process 
The auto-configuration process automatically runs when you boot the server for the first time. During the 
power-up sequence, the system ROM automatically configures the entire system without needing any 
intervention. During this process, the ORCA utility, in most cases, automatically configures the array to a 
default setting based on the number of drives connected to the server. 
  
 
NOTE:
  The server may not support all the following examples. 
  
  
 
NOTE:
  If the boot drive is not empty or has been written to in the past, ORCA does not 
automatically configure the array. You must run ORCA to configure the array settings.