Samsung cl21m2 Manual De Usuario
English - 11
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this,
see “Antennas with 300-ohm Flat Twin Leads”
below.
see “Antennas with 300-ohm Flat Twin Leads”
below.
If your antenna has one lead that looks like this,
see “Antennas with 75-ohm Round Leads” on the
next page.
see “Antennas with 75-ohm Round Leads” on the
next page.
If you have two antennas, see “Separate VHF and
UHF Antennas” on the next page.
UHF Antennas” on the next page.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the screws
on the 300-75 ohm adaptor
(not supplied). Use a
screwdriver to tighten the
screws.
twin leads under the screws
on the 300-75 ohm adaptor
(not supplied). Use a
screwdriver to tighten the
screws.
2
Plug the adaptor into the
“VHF/UHF” terminal on the
rear panel.
“VHF/UHF” terminal on the
rear panel.
I
N S TA L L AT I O N
C h a p t e r Tw o
AA68-03671A-00Eng_Latin 6/15/05 5:31 PM Page 11