Sony dav-s888 Manual De Usuario
Getting Star
ted
23
GB
WOOFER 3
Ω
IMPEDANCE
USE
EXCEPT
WOOFER 3
WOOFER 3
Ω
INTERLACE
SELECTABLE
SCAN SELECT
SPEAKER
VIDEO 1
VIDEO 2
COMPONENT VIDEO OUT
MONITOR
OUT
COMPONENT
VIDEO OUT
FRONT
R
FRONT L
REAR
R
REAR L
CENTER
COAXIAL
AUDIO OUT
L
R
L
R
L
R
VIDEO OUT
VIDEO IN
OPTICAL
DIGITAL
IN
AUDIO IN
AUDIO IN
VIDEO IN
Y
P
B
/C
B
P
R
/C
R
AM
FM
75
Ω
V I D E O
S VIDEO (DVD ONLY)
AUDIO
OUT
SUB
WOOFER
IN
IN
OUT
OUT
OUT
VIDEO
OUT
R
VIDEO
IN
AUDIO
OUT
AUDIO
IN
L
VIDEO
OUT
R
AUDIO
OUT
L
OUTPUT
VIDEO
IN
INPUT
OPTICAL
If you connect a digital satellite receiver with the OPTICAL jack
The digital satellite receiver can be connected to the OPTICAL jack instead of the VIDEO IN
and AUDIO IN L/R jacks of the system.
The system can accept both the digital and analog signals. Digital signals have priority over
analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.
and AUDIO IN L/R jacks of the system.
The system can accept both the digital and analog signals. Digital signals have priority over
analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.
If you connect a digital satellite receiver without the OPTICAL jack
Connect the digital satellite receiver to the VIDEO IN and AUDIO IN L/R jacks only of the
system.
system.
Setup for the system (for Asian and Australian models)
Setup is necessary for the system, depending on the TV monitor to be connected.
The initial setting for Asian models is NTSC but Australian models is PAL.
The initial setting for Asian models is NTSC but Australian models is PAL.
If the color system of the TV is PAL
*
To set the system to PAL, turn on the system by pressing 1 (power) on the remote while
pressing X (pause) button on the system. You need to hold the X button until DAV-S888
appears on the display. To reset to NTSC, turn off the system and then turn on again using the
remote while pressing the X button on the system.
* If the color system of the TV is NTSC, do the same operation above to set the system to
pressing X (pause) button on the system. You need to hold the X button until DAV-S888
appears on the display. To reset to NTSC, turn off the system and then turn on again using the
remote while pressing the X button on the system.
* If the color system of the TV is NTSC, do the same operation above to set the system to
NTSC.
Connecting the AC power cords (mains leads)
Before connecting the AC power cords (mains leads) of the system and subwoofer to wall
outlets (mains), connect the speakers to the system.
Connect the AC power cord (mains lead) of your TV/video components to a wall outlet (mains).
outlets (mains), connect the speakers to the system.
Connect the AC power cord (mains lead) of your TV/video components to a wall outlet (mains).
VCR
Digital satellite receiver
TV monitor