Sony DCR-HC27E. Manual De Usuario

x

(CALIBRATION)
The buttons on the touch panel may not 
work correctly. If this happens, follow the 
procedure below. It is recommended you 
connect your camcorder to the wall socket 
using the supplied AC Adaptor during the 
operation.

1

Slide the POWER switch to OFF(CHG).

2

Eject the cassette from your camcorder, 
then disconnect any connecting cables 
except the AC Adaptor from your 
camcorder.

3

Slide the POWER switch repeatedly to turn 
on the PLAY/EDIT lamp while pressing 
DISP/BATT INFO on your camcorder, and 
keep pressing down DISP/BATT INFO for 
about 5 seconds.

4

Touch the “×” displayed on the screen with 
the corner of the “Memory Stick” or the 
like.

The position of the “×” changes. If you did 
not press the right spot, start from step 

4

 

again.

• You cannot calibrate the LCD screen if it is 

rotated.

• If the casing is soiled, clean the camcorder body 

with a soft cloth lightly moistened with water, 
and then wipe the casing with a dry soft cloth.

• Avoid the following to avoid damage to the 

finish.
– Using chemicals such as thinner, benzine, 

alcohol, chemical cloths, repellent, insecticide 
and sunscreen.

– Handling with above substances on your 

hands.

– Leaving the casing in contact with rubber or 

vinyl objects for a long period of time.

• Wipe the surface of the lens clean with a soft 

cloth in the following instances:
– When there are fingerprints on the lens 

surface.

– In hot or humid locations
– When the lens is exposed to salty air such as 

at the seaside.

• Store in a well-ventilated location subject to 

little dirt or dust.

• To prevent mold, periodically clean the lens as 

described above. It is recommended that you 
operate your camcorder about once a month to 
keep it in optimum state for a long time.

,