Sony SNC-CH110 Manual De Usuario
A
d
mini
s
tra
ting
t
t
he
Came
ra
Configuring the Network — Network Menu
44
Configuring the Network
— Network Menu
When you click
in the Administrator menu, the
Network menu appears.
Use this menu to configure the network to connect the
camera and the computer.
The Network menu consists of three tabs: Network,
QoS and Dynamic IP address notification.
Use this menu to configure the network to connect the
camera and the computer.
The Network menu consists of three tabs: Network,
QoS and Dynamic IP address notification.
Network Tab
This section provides the menus for connecting the
camera through the network cable.
camera through the network cable.
MAC address
Displays the MAC address of this unit.
Ethernet status
Displays the current transmission rate.
Auto-MDI/MDIX
According to the port of the connected Ethernet device,
automatically switches the port of the unit between MDI
and MDI-X for transmission.
Displays the Ethernet port mode of the unit.
automatically switches the port of the unit between MDI
and MDI-X for transmission.
Displays the Ethernet port mode of the unit.
IPv4 setting
Configure the IPv4 network setting.
IP address
Configure the IP address.
Configure the IP address.
Obtain an IP address automatically (DHCP): Select
this option when a DHCP server is installed on the
network to allow IP address assignment. With this
setting, the IP address is assigned automatically.
network to allow IP address assignment. With this
setting, the IP address is assigned automatically.
Note
When you select Obtain an IP address automatically
(DHCP), make sure that a DHCP server is operating on
the network.
(DHCP), make sure that a DHCP server is operating on
the network.
Use the following IP address: Select this option when
you set a fixed IP address. With this setting, specify
the IP address, Subnet mask and Default gateway
manually.
the IP address, Subnet mask and Default gateway
manually.
IP address
Type the IP address of the camera.
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Type the subnet mask.
Default gateway
Type the default gateway.
Type the default gateway.
DNS server
Configure the DNS server address.
Configure the DNS server address.
Obtain DNS server address automatically: Select this
option to obtain the IP address of DNS server
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected in the
Network tab.
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected in the
Network tab.
Note
When you select Obtain DNS server address
automatically, make sure that a DHCP server is
operating on the network.
automatically, make sure that a DHCP server is
operating on the network.
Use the following DNS server address: Select this
when you set a fixed address as the IP address of the
DNS server. With this setting, specify the addresses
on Primary DNS server and Secondary DNS
server manually.
DNS server. With this setting, specify the addresses
on Primary DNS server and Secondary DNS
server manually.
Primary DNS server
Type the IP address of the primary DNS server.
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
Type the IP address of the secondary DNS server, if
necessary.
MTU
Enter the MTU value for the Ethernet port. (1000 - 1500)
If IPv6 is enabled, the value must be 1280 or greater.
Enter the MTU value for the Ethernet port. (1000 - 1500)
If IPv6 is enabled, the value must be 1280 or greater.
Network