Nokia 5140 Manuales De Servicio
Nokia Customer Care
Troubleshooting Instructions
Company confidential
NPL-4/5
Issue 1 05/04
Copyright © 2004 Nokia Corporation. All rights reserved.
Page 47
Synthesizer
Check synthesizer operation
Start Phoenix Service Software and open FBUS connection.
Select “Scan Product” (Ctrl-R or in menu File - Scan Product).
Wait until phone information is shown in the lower right corner of the screen.
Set “operating mode” to “Local”.
Set “operating mode” to “Local”.
Open window “RF Controls” (menu Testing - RF Controls)
Set the synthesizer to the following mode:
Select->Band->GSM 1800
-Active unit->RX
-Operation mode->Continuous
-RX/TX Channel->700
The setup should now look like this:
To measure the supply voltage VR7, the tuning voltage Vc and the output frequency f
VCO;
see Figure : Test points of the synthesizer.