Panasonic cf-71djxxxxx Manual De Usuario

23

Simply slide the PC Card in until it snaps into place.  Please refer to the
manual for each card on how to install the card (insertion is typically label-
side up).

Label-side up

Your computer has two PC Card slots.  These slots conform to the PC Card Standard;
therefore, communications or SCSI devices, etc., may be utilized.  The slots allow you to
use two Type I or Type II cards (or one Type I and one Type II), or one Type III card.

Two cards can be used simultaneously.

One card can be used only in the slot 1.

Please check the PC Cards’ specifications.  Be sure the total operating current
does not exceed the specified limit.  Damage may result otherwise.
Allowable Current (total for two slots) : 3.3 V:  400 mA, 5 V: 400 mA, 12 V: 120 mA
There are times when both a Type I card and a Type II card will not work at the
same time.
SRAM and FLASH ROM (except for an ATA interface) cards are not supported.
Do not use a CardBus type card and a non-CardBus type card at the same
time.
For the following cases, be sure the power has been turned off before proceed-
ing.
• When removing a network card
• When replacing a CardBus type card with another card (including another

CardBus type card)

• When inserting one more CardBus type card with one already inserted

When inserting a card, do not force the card in if difficulty is encoun-
tered.  You may damage the slot, making it impossible to remove the
card.

Pull the button out and press it.

Slide the PC Card out.

Go to [Socket Status] (in [Start] - [Settings] - [Control Panel] - [PC
Card (PCMCIA)]), select the PC Card slot and press [Stop].
(When removing a PC Card after turning off the computer, this step

 is not need.)

Do not remove a PC Card while your computer is in the suspend or
hibernation mode.