Panasonic cq-c5210u Manual De Usuario

Descargar
Página de 26
54
CQ-C5410/5310/5210/5110U
CQ-C5410/5310/5210/5110U
55
Installation Guide 
(continued)
8 Lock cancel plate
Remove the Unit
Switch off the power of the unit.
1
Remove the removable face plate. (page 49)
2
Remove the trim plate 
7 with a screwdriver.
3
1
  Insert the lock cancel plates 
8 along the 
grooves on both sides of the main unit 
until “click” is heard.
2
  Pull out the unit while pushing the plates 
further inside.
4
Remove the unit pulling with both hands.
7 Trim  plate
1
  Insert.
Insert the tab 
end in the 
outer groove.
Screwdriver
2
  Pull  out.
“Click”
E
N
G
L
I
S
H
35
E
N
G
L
I
S
H
36
Installation Procedures
The included mounting collar 
1 is designed 
specifi cally for this unit. Do not use it to attach 
any other model.
6 Power 
connector
Engage the mounting 
springs (
§) in the 
mounting holes of the 
mounting collar 
fi rmly.
The tabs to be bent vary depending on 
the car. To securely install the unit, fully 
bend a number of the tabs so that there is 
no rattling.
(b) Using the rubber cushion (option)
1
Insert mounting collar 
1 into the 
dashboard, and bend the mounting tabs out 
with a screwdriver.
2
Secure the rear of the unit.
After fi xing mounting bolt 
5 and power 
connector 
6, fi x the rear of the unit to the 
car body by either method (a) or (b) shown 
below.
3
Insert trim plate 
7.
4
After installation, 
reconnect the 
negative 
- battery 
terminal.
Mounting holes
Mounting 
springs (
§)
5 Mounting  bolt
Mounting springs (
§)
Mounting 
hole
(a) Using the rear support strap 
3
4 Tapping  screw
Fire wall of car
2 Hex.  nut
3 mm
·
3 Rear support strap
5 Mounting  bolt
1 Mounting  collar
Rubber cushion (option)
Rear support bracket
(provided on the car)
5 Mounting  bolt
1 Mounting  collar
Tab
First complete the electrical connections, and then 
check them for correctness. (page 56)
Example:
Remove the 
mounting collar 
and the trim plate 
from the main unit 
temporarily, which 
are already mounted 
at shipment.