Panasonic fz-g1 fzg1aahjb1m Manual De Usuario
29
Useful Information
2
Perform the “First-time Operation” (è page 19).
NOTE
l
The date and time, and the time zone may not be correct. Be sure to set them correctly.
3
Perform Windows Update.
4
<Only for model with TPM> Clear TPM.
A
On the Start screen, flick from bottom side to inside of the screen and touch [All apps]
on the toolbar.
B
Touch [Run] under “Windows System”, input [tpm.msc] and touch [OK].
C
Touch [Clear TPM ...] under “Actions” on the right of the “TPM Manager on Local Com-
puter” screen.
D
Touch [Restart] of the “Manage the TPM security hardware” screen.
The computer will restart.
E
When “TPM configuration change was requested to ...” is displayed, press
F12.
Windows will start.
F
When “TPM is ready” appears, touch [Close].
1
Turn on the computer, and touch the top left corner of the screen sev-
eral times while [Panasonic] boot screen is displayed.
The Setup Utility starts up.
l
If the [Panasonic] boot screen is not displayed, turn on the computer while touching the
top left corner of the screen.
l
If the password is requested, enter the Supervisor Password.
2
Write down all of the contents of the Setup Utility and touch [Exit] and
double-touch [Load Default Values].
At the confirmation message, touch [Yes].
3
Touch [Exit] and double-touch [Save Values and Reboot].
At the confirmation message, touch [Yes].
Computer will restart.
4
Touch the top left corner of the screen several times while [Panasonic]
boot screen is displayed.
The Setup Utility starts up.
l
If the password is requested, enter the Supervisor Password.
5
Select the [Exit] menu, then double-touch [Recovery Partition].
6
Touch [Reinstall Windows] and touch [Next].
The License Agreement screen appears.
7
Touch [YES].
The License Agreement screen appears.
8
Touch [Yes, I agree to the provisions above and wish to continue!] and
touch [Next].
9
Select the setting and touch [Next].
l
[Reinstall Windows to the whole Hard Disk to factory default.]
Select this option when you want to install Windows to the factory default. After instal-
lation, you can create a new partition. For how to create a new partition, refer to “To
change the partition structure” (è page 21).
CPE02725ZA_FZ-G1mk1_8_7_OI_E.indb 29
2013/02/07 10:31:19